Tuesday, October 25, 2016

Mar10 Demo Image

SENTINEL XR is the best solution for protecting medium sized networking applications which require the highest possible levels of reliability. The UPS is designed to support a wide applications from IT to security. SENTINEL XR is unique in that the UPS can be placed directly onto the floor or mounted in 19” rack mount cabinets. The range is available in 3300-4000-5000-6000-8000-10000VA models. The UPS is primarily an on-line double-conversion (VFI) technology system with further selectable operating modes that can configure the UPS to protect applications including emergency lighting, security and medical systems. Each UPS features advanced communications and diagnostics including a digital front panel display that can turned to suit the installation format, RS232 and USB interfaces, and an internal adaptor slot for SNMP and other interface card options. Watch&Save 3000 software is supplied as standard.

  • The UPS can be installed as a floor standing tower or 19” rack mount UPS. The front panel digital display can be pulled out (using the keys provided) and rotated to suite the installation format
  • Low noise level (<40dBA) thanks to the digitally PWM controlled ventilation system which is load and temperature dependent, and the use of an inverter with a high switching frequency (>20kHZ, above the audible range)
  • Optional bolt-on maintenance bypass (SENTINEL XR 5-6-8-10 kVA models) to allow service without disruption to the loads
  • Performance guaranteed in temperatures up to 40°C
  • Two IEC output plugs with thermal protection (SENTINEL XR 5-6-8-10 kVA)
  • PowerShare output socket (2x10A IEC) functionality on SENTINEL XR 5-6-8- 10 kVA models
Mar10 Demo Image
  • On line Mode (VFI)
  • Economy Mode: selects Line Interactive VI technology to power noncritical loads from mains and achieve up to 98% operating efficiency
  • Smart Active Mode: the UPS selects automatically whether to operate in Online VFI technology - full system protection or Line Interactive VI mode depending on the stability of the mains supply
  • Emergency Mode: the UPS can be set to work only when the mains fails - suitable for emergency lighting
  • Frequency converter Mode: 50 or 60Hz
  • Even with typical distorting IT loads with crest factors of 3:1
  • Increased short circuit current on the bypass
  • Increased overload capacity: 150% on inverter even when mains supply has failed
  • Reliable, filtered, stabilised and regulated sinewave output (double conversion technology VFI in conformity with IEC 62040-3 specifications) with filters for atmospheric disturbance suppression
  • Rephasing of load as the UPS has an input power factor close to 1, with a sinusoidal input current
  • Automatic and manual battery tests
  • Unique Low Ripple Current Discharge (LRCD) to help prolong battery life
  • Hot-swap user replaceable batteries
  • Unlimited extendable back-up time using modular design Battery Extension Packs
  • Increased ride through (without batteries) on mains breaks up to 40ms and for fluctuations ranging from 84 to 276Vac
  • Output voltage selection: 220-230-240Vac
  • Auto restart when mains power returns programmed using the UPS Tools software supplied
  • Bypass on: when the UPS is switched off, it automatically goes into bypass mode to charge the batteries
  • Automatic power down due to minimum load
  • End of battery discharge pre-alarm
  • Delayed start up
  • Completely digitally controlled
  • Automatic bypass with no break in power supply
  • Use of IMS (Insulated Metallic Substrates) modules
  • Status, measurements, and alarms available on the standard backlit display
  • UPS can be updated digitally (flash upgradeable)
  • Input protected by resettable thermally activated switch
  • Back-feed protection: to avoid current being fed back into the mains should a fault occur
  • Manual switch over to bypass
  • Advanced, multi-platform communication for all operating systems and network environments: Watch&Save 3000 monitoring and shut-down software included, for Windows 2008, Vista, 2003, XP; Mac OS X, Linux, Novell and most popular Unix operating systems.
  • The UPS is supplied with a communications cable for ‘Plug and Play’ PC connection
  • USB port
  • RS232 serial port
  • Interface card slot
  • Local Area Networks (LAN)
  • Data Centers
  • Servers
  • Industrial PLCs
  • Cash registers
  • Electromedical devices
  • Emergency devices (lights/alarms)
Mar10 Demo Image
  • Extended runtime solutions
  • With/without battery charger
  • External maintenance bypass(except 3300VA and 4000VA)Interface cards
  • Telescopic rails for rack cabinet

Product Survey

Popular Power Solution ?

Total Visitors


Site Login